www.TrailFX.com
Page
2
of
6
Rev 020218
INSTALLATION PROCEDURE
BUMPER IS HEAVY, ASSISTANCE IS HIGHLY RECOMMENDED TO AVOID POSSIBLE INJURY OR
DAMAGE TO THE VEHICLE.
Vehicle Preparation
1.
Disconnect the factory fog lamp connectors (If Applicable), zip tie harness to frame.
2.
Open the Hood and remove the 8 dart clips holding the plastic radiator valance
( Fig 1)
.
3.
Remove the two 7mm screws from the plastic piece from inside the wheel well
( Fig 2)
. Repeat on other side.
4.
Reaching behind the grill use needle nose pliers or a falt bladed screwdriver to pop loose all clips holding the painted
bumper section to the grill.
5.
Remove the Painted Bumper section from the front of the truck
(Fig 3)
.
Fig 1
Fig 2
Fig 3
