www.TrailFX.com
Page
3
of
5
Rev 040418
Bumper Installation
1.
Attach the license plate to the Replacement Rear Bumper
(Fig 2)
. Fasten the license plate with the hardware.
2.
Select the license plate light and push the light into the hole in the Bumper
(Fig 3)
.
3.
Install the Sensor Sleeves into sensor holes. If the sensor is not equipped, install provided plugs into the sleeves
(Fig 4A)
.
If the sensor is equipped, insert sensors from the back side, fasten each sensor with the hardware
(Fig 4B)
.
(2)5×15×1.2mm Flat Washers
(1)5mm Hex Nut
(1)5mm Lock Washer
(2)5×15×1.2mm Flat Washers
(1)5×20mm Phillips Screw
(1)Plastic Plug
Fig 2
License Plate Light
Fig 3
Sensor is not equipped
(1)Rubber Sensor Plug
Fig 4A
Sensor is equipped
(1)Allen Wrench
(1)4×10mm
Button Head Allen
Bolt
Fig 4B
