www.TrailFX.com
Page
3
of
6
Rev R01 110920
Driver/left Side Installation Pictured
(Fig 3) Thread (1) 8mm Hex Bolt
into the nut on the plate. Stop when
bolt reaches end of nut as pictured
(Fig 4) Use the loose Hex Bolt as a handle. Insert
the Bolt Plate into the oval hole and feed the
threaded end out either factory hex shaped hole.
IMPORTANT: Do not let go of the hex bolt until after
Plastic Retainer has been threaded onto bolt (Fig 5)
(Fig 5) Thread Plastic Retainer onto Bolt
Plate to hold Bole Plate in position.
Plastic Retainer
(Fig 6) Remove 8mm Hex Bolt. Rotate
Bolt Plate to line up with remaining
factory hex shaped hole
Front
8mm Flat Washer
8mm Lock Washer
8mm Hex Nut
Front
(Fig 7) Attach Bracket to
threaded end of Bolt Plate
8mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Plastic Retainer
