assembly
CIRCLE FRAME CENTER MOUNT
INSTALLATION
STEP 1.
With the footplate detached, drop the
jack into the hole located in the trailer’s coupler.
Note that the support plate on the jack has one
point that is flattened. This corner should face
forward, toward the front of the coupler.
STEP 2.
You can now fit the jack to the coupler.
Bolt sizes are specific to your coupler and are
not included with your Blackout Series Jack
purchase. Alternatively, the center jack can also
be welded for a more permanent attachment to
the trailer.
WELDED PIPE MOUNT INSTALLATION
See PIPE MOUNT INSTALLATION.
Have welded in the location of your choosing.
Ensure there is adequate room to place the jack
into stow position.
Have inner cylinder of attachment point
welded to the vertical center of an unpainted
section of your trailer frame.
BRACKET MOUNT INSTALLATION
See PIPE MOUNT INSTALLATION Steps 1-2.
SWIVEL MOUNT INSTALLATION
STEP 1.
Place the mounting bracket onto an 8
inch clearing on your frame where the jack can
freely rotate from its vertical position to its
horizontal stow position. Secure with the four
included bolts at desired height.
WARNING
The mount bracket is only to be
installed on trailer frames that are rectangular
in profile. Cylindrical frames are not compatible
with the mount bracket.
DIRECT WELD INSTALLATION
Have welded in the location of your choosing.
Have inner cylinder of attachment point
welded to the vertical center of an unpainted
section of your trailer frame.
7
Summary of Contents for blackout Series
Page 1: ...OPERATING MANUAL JACKS...