B) Attach the jack to the mounting bracket in the
vertical position and check the height.
C) Evenly and firmly tighten the 4 bolts.
STEP 3.
Set the stow pin to secure the jack and
set the cotter pin to secure the stow pin.
STEP 4.
The jack mount bracket comes with
a security bolt that is an option to secure the
device. If you choose to use it, the bolt slots
through the back of the mounting bracket and
threads into the attachment point of the jack.
assembly
PIPE MOUNT INSTALLATION
STEP 1.
The mounting bracket has 7 holes to
fit a variety of trailer frames. Have a tongue
clearance of at least 13 inches off the ground
before installing the bracket. Set aside 8 inches
of space on the tongue for mounting bracket.
STEP 2.
A) Place the mounting bracket and clamps onto
the area of the tongue you designated in Step 1,
and secure onto the tongue with 4 bolts, each
bolt having one washer, one spring washer and
one nut. Do not completely tighten the bolts yet.
NOTE: While it is recommended that the bracket
is installed with the attachment point in the low
position for stability, the bracket can be flipped
prior to install if needed.
Prior to install, raise the trailer tongue until you have adequate space to attach the jack. The unit must
be attached while the weight of the trailer is supported by an existing support or tow vehicle. Having
wheel chocks in place during connection will insure a safe install.
It is recommended that you make sure the jack will have necessary clearance from the ground to
operate and rotate into the stow position.
The trailer should be high enough so that the jack is at least 1 inch off the ground at this stage of
installation. If the jack is not high enough, adjust trailer height or mounting bracket and test again.
6
Summary of Contents for blackout Series
Page 1: ...OPERATING MANUAL JACKS...