Wiring Loom Fitting Instructions
To Suit Holden Commodore VF Sedan & Wagon
Part Number 100971-WL
Page
3 of 4
Issue Date
10-12-14
Cequent Customer Service
Ph: 1800 812 017 Fax: 03 9797 3299
Email: [email protected]
Post: PO Box 4050, Dandenong South VIC 3175
The following steps are for Holden Commodore VF Wagon models. For Holden
Commodore VF Sedan models, go back to Page 2.
1. In the luggage compartment, remove the floor carpet cover and remove the screws and
tow hooks.
2. Remove the LHS luggage compartment fuse access panel.
3. At the spare wheel plastic tub lining, drill a 30mm hole (1) into the LHS quarter.
4.
In the LHS luggage compartment rear quarter area, locate and connect the (grey) 6-way
break-out connector (1) to the trailer patch (P/No: 100971-WL) mating connector (2).
5. Connect the trailer patch ECU connector (3) to the ECU (4) and then mount ECU to the
rear quarter sheet metal panel using double sided adhesive tape ensuring the connector
end if pointing down.
6. Route the trailer patch harness towards the spare wheel well.
7. At the rear exterior underside of the vehicle, route the tail harness (tail length 1200mm) up
through the drilled out 30mm hole and into the vehicle, ensuring the grommet is seated
correctly.
8. Secure the trailer patch harness socket head to the towbar mounting plate using the
supplied M4 fasteners.
