Wiring Loom Fitting Instructions
To Suit Holden Commodore VF Sedan & Wagon
Part Number 100971-WL
Page
2 of 4
Issue Date
10-12-14
Cequent Customer Service
Ph: 1800 812 017 Fax: 03 9797 3299
Email: [email protected]
Post: PO Box 4050, Dandenong South VIC 3175
The following steps are for Holden Commodore VF Sedan models. For
Holden Commodore VF Wagon models, proceed to Page 3.
1.
In the luggage compartment, remove the four screws from the rear trim and then
remove the rear trim and the luggage compartment floor carpet.
2.
Remove the three fasteners from the LHS luggage compartment trim and then dislodge
the trim.
3.
Drill a 30mm hole into the rear LHS area of the spare wheel plastic tub lining.
4.
In the LHS luggage compartment rear quarter area, locate and connect the (grey) 6-way
break-out connector (1) to the trailer patch (P/No: 100971-WL) mating connector (2).
5.
Connect the trailer patch ECU connector (3) to the ECU (4) and then mount the ECU to
the rear quarter panel using double sided adhesive tape, ensuring the ECU connector
end is pointing down. Route the trailer patch harness towards the spare wheel well.
6.
From the rear exterior underside of the vehicle, route the tail harness (tail length
1200mm) up through the drilled out 30mm hole and into the vehicle, ensuring the
grommet is seated correctly. Secure the trailer patch harness socket head to the towbar
mounting plate using the supplied M4 fasteners.
7.
In the luggage compartment spare wheel well, connect the trailer harness 8-way
connector to the trailer patch mating connector.
8.
Test the trailer wiring harness function using a light board or multimeter.
9.
Secure all harnesses using cable ties (not supplied). Re-fit all removed parts and secure
all fasteners, ensuring there are no squeaks or rattles.
10.
Place the fitting instructions in the glove box after fitment.
