Wiring Loom Fitting Instructions
To Suit Toyota Prado Pre-MY14 and Toyota Prado MY14
Part Number 100210-WL
Page
2 of 2
Issue Date
11-12-14
Cequent Customer Service
Ph: 1800 812 017 Fax: 03 9797 3299
Email: [email protected]
Post: PO Box 4050, Dandenong South VIC 3175
1. Remove all the required trims to gain access to the LHS tail light connectors and the
LHS rear quarter area of the vehicle.
2. Connect the Trailer Patch Harness (P/No:100210-WL) to the vehicle breakout
connector.
3. Route the Trailer Patch Harness (P/No: 100210-WL) along the rear of the luggage
compartment and towards the rear RHS quarter of the vehicle.
4. Connect the Trailer Patch Harness to the ECU module (P/No: 04826).
5. Adhere the ECU module to the interior of the cavity in the area below the LHS tail light.
6. Secure the earth ring terminal to the earthing point located above the LHS tail light
cavity opening.
7. Locate the main vehicle harness grommet sitting in the floor of the LHS rear quarter
area. Drill a Ø30mm hole to the LHS of the grommet just in front of the vehicle clipping
point. File back any rough edges and spray the hole with a rust inhibitor.
8. Secure the Tail Harness (Tail length 1200mm) trailer socket (1) to the towbar mounting
bracket using M4 fasteners (not supplied).
9. Route the Tail Harness over to the previously drilled hole and feed the connector into
the vehicle.
10. Adjust the harness grommet to the required position and secure grommet with a cable
tie (not supplied) and then secure the grommet in place. Secure the harness to the
towbar using cable ties (not supplied).
11. Connect the Tail Harness 8-way male connector to the Trailer Patch Harness female
connector.
12. Test the Trailer socket using a light board or multi-meter.
13. Secure the all harnesses using cables ties (not supplied).
14. Refit all removed parts and secure all fasteners.
15. Place instructions in glove box after fitment.
