TrailBlazer Attachments TB-ONE, Operation And Parts Manual

Page: 17 / 40

Offset Mowers 17 Trailblazer Attachments, LLC
423-405-5150 February 2019
4. SAFETY SIGNS AND INSTRUCTIONAL LABELS
4.1 General Information
The types of safety signs (hazard labels) and
instructional labels, along with their locations on the
equipment, are shown in the following illustrations.
Good safety practices require that you familiarize
yourself with the various safety signs, the type of
warning, and the area or particular operation related to
that area that requires your SAFETY AWARENESS.
THINK
SAFETY!
Think SAFETY!
Work SAFELY!
Pay close attention to the safety signs and instructional
labels attached to the tractor and the offset mower.
Duplicate safety signs, which are attached to the offset
mower, can also be found in this section. If the offset
mower is missing a label or one is unreadable, replace
the label before using the offset mower.
SAFETY
INSTRUCTIONS
N ING AR
Safety Signs and Instructional Labels
1.
Keep safety signs or instructional labels clean
and legible at all times. Use a clean, damp cloth
to clean safety decals.
2. Replace any missing or hard-to-read safety signs
or instructional labels.
3. Use care when washing or cleaning the equipment
not to remove or damage the labels. When using
a pressure washer to clean the offset mower,
avoid spraying too close to decals; high-pressure
water can enter through very small scratches or
under edges of decals causing them to peel or
come off.
4. Locations for the labels and replacement part
numbers are shown in this section.
5. Replacement parts must have replacement labels
attached during installation and/or before the
offset mower is used.
6. Labels are available from your authorized dealer
or from Trailblazer at no charge.
4.2 How to Install Replacement Safety Signs
1. Clean and dry the installation area.
Note: Do not install the signs if the temperature is
below 50°F (10°C).
2. Determine the exact position before you remove the
backing paper.
3. Remove the backing paper.
4.
Align the sign over the specified area and carefully
press the sign to the part/frame.
Note: Small air pockets can be pierced with a pin and
smoothed out using the piece of backing paper.