Triad OnWall Nano LCR 3.0 w/ EasyMount Bracket - Quick Start Guide
2014.
7.23
With TV and Nano laid face down on
flat surface and speaker correctly
positioned, insert 2 EZ Mount Bracket posts
into the 2 holes on the back of the Nano.
Determine whether Nano TV Brackets’ offset
should face forward or backward depending on
Nano depth vs TV depth; determine bracket
direction (hockey stick blades facing in to TV
center or out to TV sides) depending on VESA
mounting hole spacing. The right way leaves a
gap of 7/8 inch (22.2mm) or less between the
forward face of the Nano TV Bracket and the back
of the EZ Mount BracketPost (SeeD.).
A
Install TV’s mounting bracket(s) over
Nano TV Brackets. Place the 2 Offset
Spacers between the TV’s mounting
brackets and the back of the TV over the
top VESA holes to keep the TV flat when
hung.
Determine how many 1/8” spacers fill
the gap between the forward face of the
Nano TV Brackets and the back of the EZ
Mount Bracket Posts.
Maximum is 7 spacers; if gap is greater
than 7/8 inch, reverse TV Brackets offset.
With a flat washer on the Nano TV
Bracket’s back face, determine which
screw has the right length for the stack
(if screw is too long, it interferes with
tightening the knob at the front in (F).
Tighten with Hex Key. Nano TV bracket is
now attached to TV
but not to the speaker
.
Leaving the speaker on the flat
surface, install the TV as usual; make
sure there is enough speaker wire
beneath the TV to connect to the
speaker.
1): Connect 3 pairs of speaker wires
to the Nano Phoenix connecter
preserving correct channel assign-
ment and polarity.
2): Plug the now-wired male Phoenix
connector into the Nano’s female
Phoenix connector. The speaker is
now wired.
C
B
D
E
OnWall Nano LCR 3.0 Installation with EasyMount & TV Brackets
OnWall Speaker
- Installation Instructions -
Page 2
Narrow VESA holes;
deep speaker
Narrow VESA holes;
shallower speaker
Wide VESA holes;
deep speaker
Wide VESA holes;
shallower speaker
1) 2)
Max: 7/8” (22.2mm)
Hang the Nano speaker onto the EZ Mount Bracket posts
through the speaker’s two (inner 2 if more than 1 set for large
Nanos) passthrough holes. Attach and loosely tighten the two
EZ Mount Knobs from the front of the speaker. Using the +/- ¼”
play provided, set the speaker in its final position leaving 1/8 inch
(3.1mm) gap to TV
for the grill
. Tighten the two EZ Mount Knobs.
F
To attach the grill, start at one end:
1): With the grill overlapping the speaker by approx 1 inch, seat
this end of the grill onto the enclosure.
2): Slide the near end of the grill inward so its endcap butts up to
the enclosure.
3): Snug the grill along top & bottom edges of the enclosure until
the far end snaps in. Your Nano installation is now complete.
G
1)
2)
3)
Overhead View
MAX: 3 in
76 mm
Back of TV
