TrafFix SLED, Manual

Page: 19 / 60

Revision E (Dated 11/26/12) 17
Tools and Equipment for Assembly and Installation
This list of tools is a recommendation. The actual tools required will depend on site
conditions for the assembly and installation. Personal protective equipment should always be
used during assembly and installation. Safety eyewear, steel toe boots, hard hat and gloves are
recommended as protection devices for the installer’s safety.
Documents:
Before the assembly and installation of this product, it is recommended that the complete manufactures
manual and drawing package be reviewed for clarity of the installation.
Tools:
Concrete Hole Drilling Tools: (Suggestions Would Be)
- Two Fluted Concrete Drill Bit 3/4” Diameter (w/ 8” minimum drill length)
- Rebar Cutting Drill Bit 3/4” Diameter (w/ 8” minimum drill length)
- Rebar Eater or Cutter
- Rotational Hammer Drill
Drill bits should be capable of drilling to depths of a minimum of 6 inches into the concrete barrier and
be of good quality to drill through 4000 psi concrete.
Additional Tools:
In addition to hole drilling tools, the following is suggested:
- Electrical Generator (5 kW) and Air Compressor (100 psi)
- Torque Wrench 200 ft - lbs min
- Impact Wrench 1/2” Drive
- Sockets 1/2” Drive 3/4” - 2” Nut and Bolt Size Shallow and Deep Sockets
- Ratchet and Extensions 1/2” Drive
- Adjustable Wrench 12”
- Pry/Breaker Bars
- Sledge and Ball Peen Hammers
- Chalk Line
- Concrete Marking Pencil
- Tape Measure
Optional Tools:
Tools that may also be needed: Grinder, Hacksaw, or Torc
h