traegergrills.com
|
13
INITIAL FIRING INSTRUCTIONS
To be used on initial firing or anytime the grill runs out of pellets.
In order to ensure
proper operation of the grill, you must first prime the pellet hopper's auger by allowing the auger
tube to be “charged” with pellets.
1
Remove the porcelain-coated grill grate
or cast-iron griddle and grease drip
tray from the inside of the grill.
2
With the Main Power switch in the
OFF (O) position, plug the power cord
into an appropriate grounded/earthed
electrical outlet. Once the grill is
plugged in, flip the Main Power switch
to ON (
I
).
3
Make sure there are no foreign objects
in the auger. With the grill in Idle
mode, press and hold the UP and
IGNITE buttons simultaneously. The
display will flash "Pri" and the auger
will begin priming.
4
Fill the hopper with your choice of
Traeger Hardwood Pellets. The auger
tube should take approximately 2
minutes to fill with pellets and begin
dispensing into the Hot Pot.
WARNING!
Use ONLY Traeger
®
Hardwood Pellets. Never use heating
fuel pellets in the grill.
NOTE: Once you turn on your grill, it will enter Idle mode,
and the display's dashed border will pulse. This indicates
your grill is awaiting a command, and is not actively
operating. The grill MUST be in Idle mode to prime the
auger.
3643 Ranger UCGv02.indd 13
12/4/17 4:44 PM
