5
OPERATING INSTRUCTIONS
!
Wear safety glasses which conform to ANSI Standard Z87.1 or EN 166.
!
Stand to one side of the strap while tensioning. Make sure all bystanders are clear before
proceeding.
!
Failure to follow the above could result in serious personal injury.
NEVER HANDLE OR SHIP ANY LOAD WITH IMPROPERLY FORMED JOINTS. Misformed
joints may not secure the load and could cause serious injury. Follow the joint inspection
procedures in each sealers manual.
1. Fully open the sealer handles and position the
open jaws to one end of the seal.
2. Bring sealer handles completely together to
assure a proper notch.
3. Repeat the notching operation after moving the
sealer toward the opposite end of the seal.
4. Remove the sealer. Cut the strap end with an approved cutter placed as close to the seal as
possible.
5. To avoid contact with sharp end of the strap, retract the strap end back into the strap
dispenser.
WWW.TRADITIONALTOOL.COM
For Parts & Service 1-877-862-6699