-- Wide Band Booster (Model: PODRP23)
9
User Manual
)
BS and MS port must be connected to donor antenna and service antenna
when powers supply on; otherwise the equipment will be damage for long
term use.
)
When use repeater for outdoor, the distance between donor antenna and
service antenna must be >20metes, otherwise the repeater will be damage
because isolation problem for long term use.
)
Donor antenna need to be lighting proof and lighting rod need to be install
for donor antenna installation pole outside
)
Check input power, require input power less than maximum input power of
repeater, otherwise the repeater cannot work well.
)
Keep clear for label and indicator on surface of repeater to be identified.
6.2 Installation
Installing a repeater system is really quite simple. The most difficult task in
installing the system is running the cable and does connectors.
Step 1
: Start by taking your phone up to the roof or other location outside
to find where the signal is strongest.
Step 2
: Temporarily mount the Donor (outside) antenna in that location.
You may need to adjust and move the antenna later.
Step 3
: Run coaxial cable into the building to a convenient location where
you can also get standard 220VAC power for the repeater.
Step 4
: Place the repeater in that location and connect the coaxial cable to
the Donor Side of the repeater and the donor antenna.
Step 5
: Mount your coverage (inside) antenna in a productive location.
You may need to adjust or move the antenna later.
Step 6
: Connect coaxial cable between the coverage antenna and the
repeater output port.
Step 7
: Power up the system and check for signal inside the building. If
needed, tune system by moving and or pointing the Donor and Coverage
antennas until they get the most signal possible.
www.amplificadorcelular.com PBX (1) 231 9661 Cel 310 309 9002
