7
Please note there are three additional terminals on the amplifier to allow expansion to a
4-speaker system from the one powered active unit. To set up the first stereo pair ensure the
first additional speaker is connected to the terminal marked (1). After this has been completed
additional speakers can be connected to the other terminals at position (2) in “Image 2”, if
required.
These are available as individual expansion packs and purchased as MESPP. (One passive
(slave) speaker and 10 metres of cable) per pack.
Image 2.
TROUBLESHOOTING
If a problem arises, please try the troubleshooting guide below.
If the problem is not listed please contact
www.gsme.com.au
Customer Service: 1300 301808
Customer Service Email: [email protected]
Q: Speaker has not been found during Bluetooth setup
A: Please check power cord is correctly connected into speaker and transformer.
*Before commencing any electrical work ensure the supply is switched OFF at the mains.
Q: Speaker connected but not playing from device
A: Please ensure device has good Bluetooth connection and battery power and that volume is
turned up. Failing this, turn the speaker power off then on.
Q: Can the speaker be installed into the bathroom ceiling?
A: This is not recommended, and other IP rated speakers should be used for this application
1 Year Warranty
