• Turn LUX knob clockwise to the minimum ‘-’ (night/darkness). The sensor should not
work after load switches off, provided the lux level in the room is higher than the level set
for the minimum.
Note: when testing in daylight, turn LUX knob to ‘+’ (day/bright light) position,
otherwise the sensor lamp will not work!
• Adjust the timer setting to allow the load to stay on to the desired time and performance,
then replace the outer cover and Fresnel lens and confirm it is functioning correctly.
NOTE:
• Avoid installing it on or near moving objects.
• There shouldn’t be any obstruction or moving object in front of the detection window that
can affect detection and performance.
• Avoid installing it near air temperature alteration zones such as air conditioners, central
heating, air conditioning ducts, etc.
• For safety reasons do not tamper with the unit after installation, contact the installing
electrician.
TIPS FOR SOLVING INSTALLATION PROBLEMS:
• The load doesn’t work:
a. Please check the power and load connected is correct.
b. Check if the load is functioning.
c. Check if the LUX level that is set, corresponds to the ambient light.
• The sensitivity is poor:
a. Please check if there are obstructions in front of the detection window impacting the
signals.
b. Please check if the ambient temperature is too high.
c. Please check if the signal source is in the detection field for the sensor.
d. Please check if the installation height corresponds to the height shown in the instructions.
• The sensor cannot switch the load off automatically:
a. Check if there are continual signals in the detection field.
b. Check if the time delay is set to the longest possible.
c. Check if the power corresponds to the instructions.
d. Check if the temperature is changing near the sensor, such as air conditioning or central
heating etc.
e. Check if Manual Override has been initiated.
GSM Electrical (Australia) Pty Ltd, Level 2 142-144 Fullarton Road, Rose Park SA 5067
www.gsme.com.au // Phone: 1300 301 838 // Fax: 1300 301 778
5 Year Manufacturer’s Warranty
This product has been manufactured to the highest quality standards.
This product is warranted to the original purchaser and is not transferable.
The product is guaranteed to be free from defects in workmanship and parts for a period of 5 Years from the date of purchase. Defects
that occur within this warranty period, under normal use and care will be repaired, replaced or refunded. The benefits conferred by this
warranty are in addition to all other rights and remedies of the consumer under Commonwealth, State and Territory laws in relation to
the goods or services to which this warranty relates and Australian Consumer Law. Risk in regard to the product to be repaired shall at all
times remain with the Purchaser. The warranty is given on the condition that the product to which it applies is used for the purpose and in
the manner intended by its construction and for no other purposes whatsoever. GSM Electrical (Australia) Pty Ltd shall not be responsible
for damage of any kind, caused by accidents, power surges, electrical storm damage, incorrect power current, infestation (vermin or
insect), incorrect installation, incorrect electricity or plumbing installation, improper use of controls or failure to use the product in
accordance with the operating instructions, general misuse or abuse or from normal wear and tear. Any attempt by an unauthorised
person to repair or tamper with the equipment shall render the warranty null and void.
GSM Electrical (Australia) Pty Ltd’s liability under this warranty is limited to the replacement and/or repair of the defective parts within the
warranty period and does not extend to installation or removal of the product. Acceptance of liability by GSM Electrical (Australia) Pty Ltd
contained herein is to the exclusion of any other remedy whatsoever and howsoever arising in respect of any equipment to which it applies.
