Mar-18
Product Code: 2829
Made in China to TQB Brands Pty Ltd specifications
Page 7
Visit us at www.tqbbrands.com.au
4.
OPERATION
1.
This jack is equipped with a handle position lock. To adjust the handle, release the lock
device by pulling the lever up. The lever is spring loaded so, so it should lock into the
desired position.
2.
Make sure the jack and vehicle are on a hard level surface.
3.
Always set the vehicle parking brake and block the wheels.
4.
Check the placement of the jack. The load must be centered on the jack saddle. Avoid
jack wheel obstructions such as gravel, tools, or uneven expansion joints.
5.
Position the jack under the vehicle using the manufacturer's recommended lifting
points on the chassis.
6.
Close the release valve by turning it clockwise until firmly closed.
7.
Connect compressed air supply to the jack. (Compressed air should be clean, dry, and
regulated at 100-120psi). Install an air filter/lubricator in the workshop air-line,
because water in the airline will damage the jack.
8.
Before raising the vehicle, double check and verify the saddle is centred and has full
contact with the specified lifting point.
9.
Squeeze the air trigger to lift until the saddle contacts the load. (To stop air operation,
simply release the grip on the lift control trigger). Continue to pump the jack to lift the
vehicle to the desired height.
10.
Always immediately position approved jack support stands under the vehicle at points
that will provide stable support in accordance with the vehicle manufactures
recommendations.
11.
Always lower the vehicle slowly onto the jack stands by pushing the control lever to
the DOWN position.
12.
Carefully lower the load onto the jack support stands by turning the release valve knob
on the end of the handle counter clockwise.
Lowering the Vehicle
1.
Raise the load by following Steps 5-9
2.
Raise the vehicle high enough to allow clearance for the jack support stands to be
removed by squeezing the air trigger.
3.
Carefully remove the jack support stands
4.
Grasp the jack handle firmly. Securely hold onto the jack handle so that your hands
do not slip and ensure the release valve does not lower rapidly.
5.
Carefully open the release valve by slowly turning the knob on the handle counter
clockwise.
6.
Once the load has been lowered, remove the jack from beneath the vehicle, fully
retract the ram to minimise exposure to dirt and grime.
