Product Code: 2806T
Made in China to TQB Brands Pty Ltd specifications
Page 5
Visit us at www.tqbbrands.com.au
Lowering the Vehicle
Be sure all tools and personnel are clear before lowering load.
1.
Raise load high enough to clear the jack stands. (refer 'Raising the vehicle')
2.
Remove jack stands carefully (always used in pairs).
3.
Slowly
turn the handle counter-clockwise, but no more than 1/2 full turn.
4.
Slowly lower the vehicle to the ground
5.
Maintain
control of the rate of speed at which the load lowers at all times!
6.
The more you turn the handle counter-clockwise, the faster the load will come
down.
7.
After removing jack from under the vehicle, fully lower the saddle to reduce ram
exposure to rust and contamination.
4.
INSPECTION
•
Prior to each use conduct a visual inspection checking for abnormal conditions, such
as cracked welds, leaks, and damaged, loose, or missing parts.
•
The Garage Jack shall be maintained in accordance with the maintenance
instructions. No alterations or modifications shall be made to this Jack.
•
Inspections shall be performed in accordance with this owner’s manual.
•
The Garage Jack must be inspected immediately if it is believed to have been
subjected to abnormal load or shock.
•
Owners and /or operators should be aware that repair of this product may require
specialised equipment and knowledge (refer to maintenance section).
5.
MAINTENANCE
Monthly maintenance is recommended. Lubrication is critical to jacks as they support
heavy loads. Any restriction due to dirt, rust, etc, can cause either slow movement or
cause extremely rapid jerks damaging the internal components. The following steps are
designed to keep the jack well maintained and operational.
Important:
Dirt is the greatest single cause of failure in hydraulic units. Keep the jack
clean and well lubricated to prevent foreign matter from entering the system. If the jack
has been exposed to rain, snow, sand, or grit it must be cleaned before it is stored or
used.
Important
: Use only good grade hydraulic jack oil. Avoid mixing different types of fluid
and
NEVER
use brake fluid, turbine oil, transmission fluid, motor oil or glycerine.
Improper fluid can cause premature failure of the jack and the potential for sudden and
immediate loss of load. We recommend PENRITE HYDRAULIC JACK OIL or equivalent.
