APR-22
Product Code: 2059T
Made in China to TQB Brands Pty Ltd specifications
Page 6
Visit us at www.tqbbrands.com.au
4.
OPERATION
Prior to use remove the Solid Plug and replace with the Air Vent Valve.
NOTE:
Follow the vehicle manufacturer's recommended procedures for removing the load as outlined in the vehicle service
manual or repair guide.
1.
Move the Telescopic Transmission Lifter into position.
2.
Move the foot pedal (33) up and down to raise the lifting platform assembly (35).
3.
Adjust the lifting platform travel screw and the angle adjustment screw to align with the shape of the transmission.
4.
Adjust the claws and the securing chain to secure the transmission on the table.
5.
Remove the transmission from the vehicle.
6.
Press the release pedal (20) fully to slowly lower the load.
7.
Reverse this procedure when mounting the transmission.
NOTE:
The speed of lowering is mechanically controlled by fully pressing down on the pedal (20). This ensures the decent
is slow and controlled.
WARNING
: Dangerous dynamic shock loads are created by quick opening and closing the release valve when the load
is being lowered. The resulting overload may cause hydraulic system failure which could cause property damage and/or
severe personal injury.
5.
INSPECTION
Prior to each use conduct a visual inspection checking for abnormal conditions, such as cracked welds, leaks, and damaged,
loose, or missing parts.
•
The transmission lifter shall be maintained in accordance with the maintenance instructions. No alterations or
modifications shall be made to this transmission lifter.
•
Inspections shall be performed in accordance with this owner’s manual.
•
The transmission lifter must be inspected immediately if it is believed to have been subjected to abnormal load or shock.
•
Owners and /or operators should be aware that repair of this product may require specialised equipment and
knowledge (refer to maintenance section).
6.
STORAGE
This
transmission lifter should always be stored in a dry location on a level surface with the
cradle fully lowered and the air
vent valve closed
.
7.
MAINTENANCE
Monthly maintenance is recommended. If this transmission lifter is in constant use. drain and refill with good quality hydraulic
jack oil once a year. The level of oil should be maintained to minimum of 6mm below the air vent screw. Top up with quality
hydraulic jack oil eg. ISOVG32 hydraulic oil. DO NOT use brake/trans fluid or engine oil. Lubricate the wheel axles and all
pivot points with engine oil or similar lubricant every month.
The hydraulic cylinder assembly of this transmission jack contains hydraulic fluid that must be kept at approximately 90% full
at all times for proper operation. To check the level and to fill:
1.
Allow the lifting platform assembly to lower completely.
2.
Remove the reservoir breather/bung.
3.
Make a visual inspection inside the oil tank opening. The hydraulic fluid must be approximately 90% of the capacity of
the hydraulic cylinder.
4.
Fill oil tank with clean hydraulic fluid oil of a high quality.
5.
Replace reservoir breather/bung and open the breather for operation.
Important
: Use only quality ISOVG32 hydraulic jack oil. Avoid mixing different types of fluid and
NEVER
use brake fluid, turbine
oil, transmission fluid, motor oil or glycerine. Improper fluid can cause premature failure of the transmission lifter and the
potential for sudden and immediate loss of load. We recommend ISOVG32 or equivalent.
Important:
Dirt is the greatest single cause of failure in hydraulic units. Keep the transmission lifter clean and well lubricated
to prevent foreign matter from entering the system.
