APR-22
Product Code: 2059T
Made in China to TQB Brands Pty Ltd specifications
Page 5
Visit us at www.tqbbrands.com.au
ASSEMBLY, OPERATION, PREVENTITIVE MAINTENANCE
1.
FEATURES
This 2-Stage hydraulic TradeQuip “Made for the Trade” Telescopic Transmission Lifter offers a wide range of versatility
designed to help increase workshop productivity. Rated to safely work with Transmissions from vehicles with a GVM of less
than 2,000kgs, the universal mounting head provides a wide fore and aft tilt range. The foot operated manual hydraulic system
has a smooth hydraulic lift and descent. The foot operated pump with a foot release valve lever provides a steady and
mechanically controlled safe descending speed.
2.
ASSEMBLY
Unpack the product and check contents with the exploded drawing and the parts list. Should there be any damaged or missing
parts, contact your place of purchase immediately.
1.
This Telescopic Transmission Lifter is built by combining the hydraulic power unit, wheel stand units and cradle unit.
2.
Connect the two wheel stands (4) with the base of the power unit (9) by inserting the bolts (1) and lock washer (2) washer
(3) into the two holes on the power unit and tighten.
3.
Assemble the four swivel castor wheels (8) together with the washer (7) lock washer (6) on each of the four ends of the
wheel stands (4) and tighten the nuts (5).
4.
Locate the two angle plates (74) and two plates (75) assemblies. Attach them to the cradle assembly (66), using bolt (76)
and tighten securely.
5.
Attach two shackles (68) and two chains (67) to the plates (75) using shackle bolts (69) and nuts (53).
6.
Attach the cradle set (48) onto the top of the Ram2 (39) and slip it down, using bolt (59) and tighten it.
OPEN BREATHER VALVE BEFORE USE
3.
BEFORE USE
Ensure Breather Valve is open before use.
Prior to use conduct a visual inspection checking for abnormal conditions, such as cracked welds, leaks, and damaged, loose,
or missing parts.
Bleed Hydraulic Transmission Lifter:
1.
Remove the Filler Bung/Breather and if required, refill with ISOVG32 hydraulic oil, until the oil is lapping the bottom of
the filler hole then replace the Filler Bung/Breather and open the Breather air vent screw.
2.
Pump the pedal to Lift Rams to full extension.
3.
At full extension resistance will be felt at the pedal and the pedal travel will stall.
4.
Whilst holding down the release/lowering pedal, continue to pump the pump/raise pedal approximately 10 times then
open the release and allow the lift ram to completely retract.
5.
This procedure will have circulated the oil through the release and pressure circuits simultaneously bleeding the pump
mechanism.
6.
If necessary, repeat the process steps 2 to 4.
At this point both the Pump and Lift Ram should be free of air and the Jack ready for operation
If the pump still feels spongy or load is slow to raise, seek the services of a qualified Hydraulic repairer.
*The TradeQuip range of transmission lifts use ISOVG32 Hydraulic Oil for the correct operation and compatibility with the seals used in
their construction.
