8
1035 309
94
1018,1021,1022 299 91
1026,1513 299
91
A36(SHAPES),1040
269 82
1042,1541 249
76
1044,1045 219
67
1060 199
61
1095 184
56
8615,8620,8622 239 73
4340,E4340,8630 219
67
Ni-Cr-Mo
Alloy Steel
8640
199
61
E9310 174
53
A-6 199
61
A-2 179
55
Tool Steel
A-10 159
49
D-2 90
27
H-11,H-12,H-13 189 58
Stainless
Steel
420 189
58
430 149
46
410,502 140
43
414 115
35
431 95
29
440C 80
24
304,324 120
36
304L 115
35
347 110
33
316,316L 100
30
416 189
58
TELLTALE CHIPS
Chips are the best indicators of correct feed force. Monitor chip information and adjust
feed accordingly.
Thin or powdered chips – increase feed rate or reduce band speed.
Burned heavy chips – reduce feed rate and/or band speed.
Curly silvery and warm chips – optimum feed rate and band speed.
9.USE OF MAIN MACHINE PARTS
9-1.POWER SYSTEMS AND CONTROL PANEL
The electrical rating of your band saw is either with 230 volt-single phase, or 400 volt-3
phase, magnetic control.
Before connecting your machine to an electrical power system, be sure the motor shaft is
running in the correct direction.
We recommend that 1.5mm² fused with a 10 amp, dual element, time lag fuse, to be used to
supply power to all machines regardless of their electrical rating.
Refer to the electrical wiring diagram supplied with your machine for instructions
on how to connect saw to power source. Power must be cut off when wheel cover
is opened or during repairing.
Please check the moving direction of the blade. If the blade is moving in the wrong direction,
please re-connect the wire.
9-2.STARTING AND STOPPING MACHINE
1.
Light (D) will be on when power is connected.
2.
Start the motor by turning the start button (C), Push the button (E) to start blade
saw. Unhand button (E) stop The motor.
3.
Turn (A) ( 0-close,1-open) to open the coolant system
4.
When saw blade is closing work piece. Or when the cut is completed, turn off the
coolant system (A)
5.
Press emergency button (B) to shut-off the motor when in emergent situation.
B
A
C
E
