INSTRUCTIONS FOR USE
The kit uses a non-refillable oxygen cartridge
(white) and a non-refillable gas cartridge
(yellow or blue). These must be purchased
separately. See specifications on page 7.
Before beginning the work, ensure
the valves of the torch are closed.
Make sure that:
•
The 11 torch oxygen valve
is
completely closed by turning the blue
knob in a clockwise direction.
•
The 12 torch fuel valve
is completely
closed by turning the orange
knob in clockwise direction.
•
The 2 oxygen cartridge regulator
valve
is completely closed by turning the
blue knob in a clockwise direction.
•
The 4 fuel cartridge regulator valve
is completely closed by turning the
orange knob in a clockwise direction.
•
Both pressure regulators
are completely
tightened on the cylinder (clockwise direction).
TO IGNITE
It is recommended that in normal use
the pressure regulator knobs are opened
completely, with flame adjustment controlled
by the torch knobs. For storage, transport
and cartridge replacement, the pressure
regulator knobs should be completely closed.
1. Turn the blue knob of the oxygen cartridge
pressure regulator
2
in an anti-clockwise
direction until fully open. Turn the orange knob
of the fuel cartridge pressure regulator
4
in
an anti-clockwise direction until fully open.
2. Turn the orange fuel knob of the torch
12
anti-clockwise to open
and immediately
ignite the torch using an ignition source
(striker
16
included with the kit).
Note that if the fuel knob allows too
much fuel, the flame will not ignite.
3. Regulate the pressure of the fuel using the
fuel knob on the torch until the yellow flame
remains attached to the tip of the torch.
Torch valve knobs
-/OFF
+/ON
12
11
-/OFF
Cartridge Regulator Knobs
+/ON
2
4
4
