CHANGING THE BATTERIES
1.
Using 2 fingers, press and open battery cover at the end of tool
2.
Insert 3 x AA 1.5V alkaline batteries into the tool, following diagram on the
label on Craft Tool
3.
Close battery cover properly - do not force it close
GETTING THE MOST FROM YOUR TRADEFLAME CRAFT KIT
Tips, Tricks, and Techniques for Better Results
The best way to get started is to familiarize yourself with the Craft Tool,
the various tips and the patterns they create.
Do not attempt to use the Craft
Tool on materials likely to melt (plastic, synthetics or imitation leather)
z
Hot Fix Tradeflame Craft Kit 10000611: Test the hot fix tip by adding crystals
to an off cut of the chosen piece of fabric. This allows you to get a feel for
how the fabric will respond and to get your creative juices and technique
flowing
GETTING STARTED
Always use the tool on a heatproof and uncluttered table.
TIPS AND THEIR USES
Your new Tradeflame Craft Kit comes with a crystals and specialty tips
depending on which kit you have purchased. To get the most from your kit,
follow these instructions to create the results you want.
1.
Flat tips can work on any size or irregular shape embellishments.
z
Keep your tip clean for good performance and long life. Clean cool tip with a
damp sponge after use – do not file tip
z
For domestic use only. Use only for the intended purposes
OPERATION
1.
Remove protective cap from the tool
2.
Place Craft Tool on the safety stand and switch to on.
3.
Wait for the tool to heat up in approx. 10 seconds
4.
Work on a flat hard counter top (ironing boards are too soft).
5.
Hold the Craft Tool like a pencil.
Do not touch any of the metal parts, as
they are hot.
6.
Do not exert pressure on the embellishment. Let the hot tip do the work
USE ARRANGE PATTERNS WITH TWEEZERS
1.
Use Tweezers provided to arrange the embellishments into desired pattern
on the fabric surface with the embellishments facing up. (fig 1)
2.
Wait for the tool to heat up in approx. 10 seconds (fig 2.)
3.
Hold the Craft Tool perpendicular to each embellishment and wait for
approximately 10 seconds.
NOTE: Time differs with different size and glue
type of the embellishments
. (fig 3)
4.
If the crystal gets stuck, use tweezers to help
5.
Repeat the process until each embellishment is hot-fixed.
6.
Allow embellishment to cool before touching.
1.
2.
3.
