7
PNEUMATIC
OPERATING INSTRUCTIONS
Pneumatic controls will have one, two, or three round push buttons
depending on the options.
DANGER:
KEEP HAIR AND CLOTHING A MINIMUM OF 12” AWAY FROM ALL SUCTION FIT-
TINGS AT ALL TIMES. PERSONS WITH LONG HAIR SHOULD EITHER SECURE THEIR HAIR TO A
MINIMUM LENGTH OR WEAR A BATHING CAP.
CHILDREN SHOULD NOT BE LEFT UNATTENDED AT ANY TIME IN THE UNIT.
WHIRLPOOL
1) DO NOT START THE PUMP UNTIL ALL WATER JETS ARE COVERED COMPLETELY.
2) To activate the whirlpool press the round pneumatic button once.
3) To deactivate the whirlpool press the round pneumatic button again.
THERMAL AIR
1) The Blower has three speeds. Press the round button once for high, press a second time for medium, press a
third time for low speed, and to turn the blower off press the button a fourth time.
2) The unit will run for twenty minutes and turn itself off. If you desire to restart the unit for another twenty
minute cycle, repeat step one.
3) When the unit is turned off for the final time, the purge cycle is started. After twenty minutes the unit will
automatically turn itself on for one minute. The purpose of the purge cycle is to flush any residual water out
of the system. It is necessary for the unit to be drained prior to the purge for it to be affective.
Important Note:
Any time you put water into the unit and do not turn on the Thermal Air (i.e. take a shower,
clean the unit, or take a soaking bath) one must turn the unit on and then off as detailed above. This will start
the purge cycle to flush the system of residual water.
7612 Drag Strip Road – Fairview, TN 37062 – 615/799-8300 – www.tradewindinc.com
