3
RECOMMENDED PRECAUTIONS
1) Upon receiving your unit, remove it from its protective packaging and inspect it for damage which may have
resulted in transit.
2) Any alterations, additions, or deletions made to the unit’s plumbing system, pump/blower motor, or any devi-
ation from the recommended installation instructions WILL VOID THE WARRANTY.
3) Literature dimensions are for reference only. Actual measurements should be taken from the tub.
4) NEVER PICK THE UNIT UP BY ITS PLUMBING AS THIS CAN CAUSE SEVERE DAMAGE TO THE
PLUMBING SYSTEM. Any damage to the system stemming from mishandling will not be covered under
the warranty.
5) All electrical wiring should be done by a licensed electrician and should comply with all applicable local
codes.
6) Location of the TIMER or SWITCH for the unit must be in compliance with all local codes to eliminate the
possibility of electric shock. THE UNITS POWER SOURCE MUST BE ON A GFCI (GROUND FAULT
CIRCUIT INTERRUPTOR).
7) ALL BUILDING MATERIALS AND WIRING SHOULD BE ROUTED AWAY FROM THE PUMP/
BLOWER OR ANY OTHER HEAT PRODUCING COMPONENTS.
8) UNDER NO CIRCUMSTANCES should the whirlpool system be activated when there is no water in the
system. The water level must be at least one inch above the circulating jets or damage to the system may
occur. The Thermal Air system can be activated when there is no water in the unit without risk of damaging
the system.
9) The TRADEWIND UNIT does not include a system for filtration. Therefore, it is recommended that the sys-
tem be drained immediately after every use.
7612 Drag Strip Road – Fairview, TN 37062 – 615/799-8300 – www.tradewindinc.com
