TracVision M1 User’s Guide
32
Chapter 4 - Setup
Additional Receiver(s) - Run One Check Switch Test
If any receivers are connected to the “Stacked Output” jack on the
interface box, follow these steps to run a single Check Switch test on
each additional receiver, one at a time.
1.
Temporarily disconnect the primary receiver from the
“Unstacked Output” jack on the interface box. Connect
the additional receiver in its place.
2.
Perform Steps 1-5 on
3.
Wait 15 minutes, then verify that the values displayed
on the TV match those shown in Figure 15. If the values
do not match, try running another Check Switch test.
You do not need to run a Check Switch test on an additional
receiver if it was
preconfigured
by KVH for your desired DISH
Network satellites.
IMPORTANT!
