14. Place the antenna baseplate over the mounting holes
drilled in the foundation, ensuring the connectors face the
stern.
15. At each of the four baseplate mounting holes, place an
M10 lock washer and flat washer on an M10 bolt and
insert the bolt into the hole from below, as shown in
Figure 2-11. Tighten all four bolts securely until the four
feet are bottomed against the mounting surface.
Figure 2-11
Bolting the Antenna Unit to the Deck (Side View)
16. Unfasten the tie-wrap securing the antenna frame to the
sensor bracket
(release the tab using a flat-head screwdriver)
.
Save the tie-wrap in case the antenna needs to be
reshipped someday.
Figure 2-12
Antenna Frame Shipping Restraint
54-0198
30
TracVision G8 Owner’s Manual - Guide to Technical Information
M10 x 50 mm Bolt
Antenna Unit Base
Deck
M10 Flat Washer
M10 Lock Washer
10 mm max.
Tie-wrap
Sensor
Bracket
Frame
Ensure the mounting screws do not
extend further than 0.4" (10 mm)
into the antenna baseplate.
Inserting the screws any further will
damage the antenna.