33
5.
Using a utility knife, carefully remove any
residual plastic from the center conductor, if
6.
Insert the end of the cable into the #2 end of
the ST-400EZ stripping tool (see Figure 61).
Then rotate the tool clockwise around the
cable until the tool turns easily. This removes
the cable jacket from the end of the cable,
exposing the braid and dielectric (see
7.
Using the DBT-02 tool, deburr and chamfer
the center conductor (see Figure 63). Avoid
nicking the aluminum tape covering the
dielectric.
Figure 60: Removing Plastic Residue
Figure 61: Stripping the Cable Jacket
Figure 62: Cable Stripped, Exposing Dielectric
Figure 63: Deburring the Center Conductor
Continued
Terminating LMR-400-75 Cable
A
