Antenna Power/Data Cable Shroud
1
Addendum
PLEASE READ!
Important Addendum to the Installation Guide
A cable shroud is now provided in the kitpack to protect the wires of
the power/data cable. Before you connect the power/data cable to the
belowdecks equipment, follow these steps to attach the shroud.
a.
Wire the power/data cable to the terminal strip
connector as directed in the Installation Guide.
b.
Place the terminal strip connector into the base of the
cable shroud, as shown in Figure 1.
Figure 1 Power/Data Cable Shroud
c.
Secure the end of the power/data cable to the base of
the shroud using the supplied clamp. This clamp will
help relieve stress on the cable. Secure the clamp in
place with the two screws.
d.
Carefully fit all of the cable’s wires within the base of
the shroud.
e.
Snap the shroud’s cover onto the base. Be sure not to
pinch any wires between the cover and the base.
f.
Plug the terminal strip connector into the rear panel of
the belowdecks equipment, as directed in the
Installation Guide.
Power/Data Cable
Clamp
Terminal Strip Connector
Cover
Base
54-0896 Rev. A
