TracPhone V3-IP, User Manual, Page: 71 / 153

TracPhone V3-IP User’s Guide
71
Network Configuration
Reset to Factory Configuration
If the system’s network becomes corrupted such that you can no
longer access the TracPhone V3-IP web interface, you can reset the
system to its original factory settings.
The following settings are included in the reset:
• Reverts to Standard (DHCP) physical Ethernet port configuration
• Deletes any custom CommBox configurations
• Clears any configured no-transmit zones
• Sets the ICM’s LCD brightness to High
To reset the system to its factory settings, follow these steps:
1. At the ICM’s front panel, press MENUS until the display
shows “DIAGNOSTIC TOOLS.”
2. Press ACCEPT .
3. At “KVH SUPPORT IP,” press NEXT .
4. At “CALIBRATE GYROS,” press NEXT .
5. At “FACTORY RESET,” press ACCEPT .
6. At “PROCEED WITH RESET?,” press ACCEPT .
The system reverts to its original factory settings. Do not power off the
system while this reset is in progress.
Important!
Perform a factory reset only if directed by KVH Technical Support.
This function should only be used as a last resort when all other
options fail.