ARTIO WB227 Wheel Barrow
WB227 Wheel Barrow
Page 7
5.0 Preparing for Use
5.1
Attaching to the Power Unit
The ARTIO WB227 Wheel Barrow will need to be attached to the power unit. This
is achieved as follows.
BCS 738 - BCS 740 - BCS 618 - BCS 630 - BCS 630WS
To attach the Wheel Barrow directly to the power unit, couple the implement to the
machine PTO and make sure the nuts are tightened securely.
If the Implement Quick Coupling Assembly is being used then simply move the
locking pin lever to raise the pin, then slide the male (blank) coupler (fitted to the
Wheel Barrow) into the female coupler (fitted to the power unit) until the slotted
hole lines up with the locking pin. Once the couplers are lined up in the correct
position, release the locking lever to secure the two couplers together (Figs. 5 & 6).
BCS 750 - BCS 660HY
The Wheel Barrow is mounted directly to the machine coupler (Fig 7,A) by attaching
the coupler (Fig 8,C) that is fixed to the implement.
To fit and remove the Wheel Barrow simply rotate the knob (Fig 3,R). The device
is locked by turning the knob clockwise and unlocked by turning the knob anti-
clockwise. It is important that nuts (Fig 8,D) are well tightened.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
