109
Disassembling Input Shaft
1. Remove the actuator as shown above.
2. Remove the four Torx T-40 cap screws.
XX405
3. Remove the assembly. Account for a gasket.
XX406
4. Remove the yellow plug; then, using a good quality
2 mm Allen wrench, remove the cap screw. Account
for the small spring.
NOTE: DO NOT use a ball head Allen wrench or
one that is worn. Make sure the wrench is properly
seated in the cap screw. Failure to do so will cause
damage to the cap screw.
XX407
5. Use an awl or similar tool to hold the slider shaft
while removing the cap screw.
XX408
6. Inspect each component for wear or damage; replace
if necessary.
XX409
7. Remove the snap ring only if the shift fork or spring
needs to be replaced.
XX410
8. To remove the input shaft, remove the snap ring from
the inside of the housing.
XX411
9. Slide the shaft out of the housing by hand.
Summary of Contents for 2262-827
Page 1: ...XTR1000 SERVICE MANUAL p n 2262 827 7 19...
Page 61: ...60 XX998cc_18_1...
Page 157: ......
