P R O F E S S I O N A L C O N S T R U C T I O N M A R K E R S
®
Warning:
Do not apply excessive force through the guide point, this may cause
damage to the surface being marked against.
KEEP AT 90º
Parallel Scribing
Adjust the pencil position as per the Setup Guide overleaf to the
required offset distance, ensuring the offset distance meets/exceeds
the largest gap between the surface being marked, and the guide
surface.
While Ensuring the guide point face remains in contact with the guide
surface, press the pencil lead against the surface to be marked and
move the tool laterally to begin marking.
Note: depending on the application the top or bottom face of the
guide point can be used.
1.
2.
Adjust the pencil position as per the Setup Guide overleaf ensuring
the offset distance meets/exceeds the largest gap between the
guide surface and marking surface.
While ensuring the guide point is lightly pressed against the guide
surface, move the tool laterally to begin marking.
Profile Scribing (Contour)
Note: To maintain accurate scribing the tool must be perpendicular
(90 degrees) to the guide surface at all times!
For profiles that are deeper than the guide point, or where longer
straight scribing is required the parallel mode may be preferred.
1.
2.
Adjust the pencil position as per the Setup Guide overleaf to match
the radius requirement.
While ensuring light pressure is applied to the guide point, rotate to
tool to start a marking.
Compass
Note: When setting the tool to mark a hole, remember to halve the
hole diameter to calculate the tool offset distance/radius to ensure
the hole is the correct size.
1.
2.
HOW TO (SETUP OVERLEAF)
