Page
13
of
20
5 Set into operation
Please mount MODUL NO.1 vertically to avoid antenna area is covered.
5.1 Connecting Transmitter (TX) and Receiver (RX)
5.1.1 Connecting Transmitter
1.) Use D-Tap adapter cable to connect Transmitter (TX) and power supply, please make sure that
power supply range is within 10.5V to 36V DC.
2.) Use SDI1-Input to connect Transmitter and video source via SDI-cable.
3.) SDI2 can be used as Loop-through.
5.1.2 Connecting Receiver
1.) Use D-Tap adapter cable to connect Receiver (RX) and power supply, please make sure that
power supply range is within 10.5V to 36V DC.
2.) SDI1 and SDI2 each can be used as output.
5.1.3 System Start-up
1.) Switch the Transmitter on using the on/off switch (6).
2.) Switch the Receiver on using the on/off switch (6).
In delivery state, Transmitter and Receiver are paired and will automatically link after the system
has been started. The Field strength display (5) will blink during connection build-up.
Connection setup is completed. Continuous lit of Field strength display (5) at Transmitter (TX) and
Receiver (RX) indicates the connection has been setup successfully. If a valid video signal is applied it
will be transmit to Receiver (RX).
Summary of Contents for MODUL NO. ONE
Page 20: ......
