May-20
Product Code: PROTRJA20T
Made in China to TQB Brands Pty Ltd Specifications
Page 6
Visit us at www.tqbbrands.com.au
4.
OPERATION
1.
This jack is equipped with a handle position lock. To adjust the handle, release the lock device by pulling the lever up. The
lever is spring loaded so, so it should lock into the desired position.
2.
Make sure the jack and load are on a hard level surface.
3.
Always set the vehicle parking brake and block the wheels.
4.
Check the placement of the jack. The load must be centred on the jack saddle. Avoid jack wheel obstructions such as
gravel, tools, or uneven expansion joints.
5.
Position the jack under the load using the manufacturer's recommended lifting points on the chassis.
6.
Connect compressed air supply to the jack. (Compressed air should be clean, dry, and regulated at 120-170psi). Install an
air filter/lubricator in the workshop air-line, because water in the airline will damage the jack.
7.
Rotate the lever RIGHT to the UP position. (To stop air operation, simply release the grip on the lift control trigger).
Continue to pump the jack until the head cap reaches the load.
8.
Before raising the load, double check and verify the saddle is centred and has full contact with the specified lifting point.
9.
Rotate the lever RIGHT to the UP position (To stop air operation, simply release the grip on the lift control trigger).
Continue to pump the jack to lift the load to the desired height.
10.
Always immediately position approved support stands under the load at points that will provide stable support in
accordance with the vehicle or load manufactures recommendations.
11.
Always lower the load slowly onto the support stands by rotating the lever LEFT to the DOWN position.
12.
Carefully lower the load onto the support stands by rotating the lever to the DOWN position
Lowering the load
1.
Raise the load by following Steps 2-9
2.
Raise the load high enough to allow clearance for the support stands to be removed by rotating the lever to the Right
UP position.
3.
Carefully remove the support stands
4.
Grasp the jack handle firmly. Securely hold onto the jack handle so that your hands do not slip and ensure the release
valve does not lower rapidly.
5.
Carefully open the release valve by slowly rotating the LEVER to the LEFT DOWN position.
6.
Once the load has been lowered, remove the jack from beneath the load, and fully retract the ram to prevent exposure
to dirt and grime.
5.
INSPECTION
Prior to each use conduct a visual inspection checking for abnormal conditions, such as cracked welds, leaks, and
damaged, loose, or missing parts.
The jack shall always be maintained in accordance with the maintenance instructions (Section 7). No alterations or
modifications shall be made to this Jack.
Inspections shall be performed in accordance with this owner’s manual.
The jack must be inspected immediately if it is believed to have been subjected to abnormal load or shock.
Owners and /or operators should be aware that repair of this product may require specialised equipment and knowledge
(refer to maintenance section).
6.
STORAGE
This jack should always be stored in a dry location on a level surface with the lift ram pistons in the fully retracted position,
where it will not be exposed to corrosive vapours, abrasive dust, or any other harmful elements.
