21
9 Software instructions
9.1 Operating instructions
1.
Press ‘Connect’ after you install the software, if it appear the ‘software
successfully connected’, then you can go on next step, if it failed, please
check the drive and the connection status.
2.
Now we are in the ‘Calibration’ interface, it will enter the operation interface
after you finished the calibration.
Note
：
It must calibration before you start any operation step.
3. If it need re-
connect, just need press the ‘Connect’, no need to close the
software.
9.2 Interface description
The main interface has two parts: toolbar and 5 functions
1. Related information: you can set it in the software system, and it would
display it when you print
.
2. Measurement interface: show the related data of the standard measured
and sample measured.
3. Color simulation: display the simulation color of the standard and sample.
4. Color difference graph: display the difference location in the color space of
the standard and sample
5. Color-difference histogram:
show the tolerance between the sample and
standard of every batch
