TPI 580, User Manual

Page: 4 / 5

Title : Tpi580
4/5

CMM or CFM measurement – Display x1, x10, x100. 9999900 CMM, 9999900 CFM

Record

DUCT: Round DUCT setting. Record: Point Record setting.

Hot wire probe

Vane probe
5. Measurement

Power on to push the Power key for more than 2 sec. ( Display All

Model#)

oPEn displays when the probe is not connected.

Only back light key and power key work in this condition.

Connect the Hot wire probe and display ‘H—d’.
Main screen: Inverse counting for 5 sec

Hot wire warming up on Hot wire probe.
H -- d : Hotwire warming up Delay

Vane Probe connect

Display the air velocity without delay.

Measure the air velocity.
6. UNIT setting

Push the UNIT key.

SET display. Display the Air velocity unit. Change the unit to push the UP, Down key.

Push the Right key when the right unit blinks. CMM, CFM blink next and change to push the Up, Down
key.

Push the Right key when the right unit blinks. The temperature unit blink next and change to push the
Up, Down key.

Push the Right key when the right unit blinks. The area unit blink next and change to push the Up, Dow
n key.

Push the Enter key and set the unit.
7. Record

Push the REC key.

SET display. Choose Point or Time to push the Up / Down key.

Choose Time , Point to push the Enter key.

Time: Push the Enter key and capture the measurement value at 1 sec interval.
(Start / Stop the capture with the Enter key.)

Point: Capture with each Enter key.

Record mode: MAX

MIN

AVG with REC key.

Record data is cleared when your push the Left key on Record Stop.

Transfer from Record mode to General measurement mode to push the REC key more than 2 sec.