9
www.tpcdental.com
10.
Installing assistance side touch pad. Remove the 5 screws that secure the covers together
Figure 10.1. Open the assistance holder and remove the 4 additional screws that attach
the bottom of the holder to the support frame in figure 10.2. Route the touchpad wire as
shown in figure Attach the touchpad bracket shown in figure 10.3.
11.
Install the lower assistance cover over the 2 screws from the touchpad bracket. Install the
washers and nylon nuts for the touchpad screws shown in figure 11.1. Connect the Molex
connector from the touchpad to the wire harness shown in figure 11.2. Re-install the 5
screws to secure the top cover back onto assistance holder in figure 11.3.
12.
Take the white 13 pin Molex connector that travels from the flex arm and route it to the
backside of the PMU to the PCB board Figure 12.1 / 12.2. Connect the harness to the
main PCB as shown in figure 12.3.
Figure 10.1
Figure 10.2
Figure 10.3
Fi
gu
re
1
1.
1
Figure 11.2
Figure 11.3
Figure 12.1
Fi
gu
re
1
2.
2
Figure 12.3