07
Gigabit Uplink Unmanaged Switch
114 Product Installation
Desktop Installation
■
To install the device on the desktop, please follow the steps:
Set the device on a flat surface strong enough to support the entire weight of the
1.
device with all fittings.
Remove the adhesive backing papers from the rubber feet.
2.
Turnover the device and attach the supplied rubber feet to the recessed areas on
3.
the bottom at each corner of the device.
Notch
Bottom of the Device
Feet
Figure 2-1 Desktop Installation
Rack Installation
■
To install the device in an EIA standard-sized, 19-inch rack, follow the instructions
described below:
Check the grounding and stability of the rack.
1.
Secure the supplied rack-mounting brackets to each side of the device with supplied
2.
screws, as illustrated in the following figure.
Rack-mounting Bracket
Screw
Figure 2-2 Bracket Installation
After the brackets are attached to the device, use suitable screws (not provided1 to
3.
secure the brackets to the rack, as illustrated in the following figure.
Installation
