8
SFP PON slots installs standard ITU-TG.984.2Class B+ or ITU-TG.984.2Class C+OLT SFP .The
OLT SFP interface is SC/PC. Please use the patch cord with SC/PC connector to connect
between the OLT and the ODN networking.
3.4.3 Ground Cable Connection
Ensure the safety and reliable working of OLT. P1200-08 should be connected with the ground if
necessary. Grounding screws are located in the rear panel. While connecting, you should use
screwdriver to loosen the grounding screw first, then connect the ground cable, finally tighten the
screws.
3.4.4 Management Port Connection
P1200-
08 equipment provides console interface (marked as “CONSOLE” RJ45 type port) and
MGMT management internet access (marked as “MGMT” RJ45 type port).
Console access is really only required when initially configuring a device, or if remote access fails.
Console access requires:
Console cable: RJ-45-to-DB-9 console cable
Terminal emulation software: HyperTerminal
The cable is connected between the serial port of the host and the console port on the device.
Most computers and notebooks no longer include built-in serial ports. If the host does not have a
serial port, the USB port can be used to establish a console connection. A special USB-to-RS-232
compatible serial port adapter is required when using the USB port.
Figure 3-1 Connecting the Console Port
Port on Computer
Cable Required
Port on OLT
Serial Port
RJ-45 to DB-9 Console Cable
RJ-45 Console Port
USB Type-A Port
USB to RS-232 compatible
serial port adapter ( Adapter
may require a software driver )
RJ-45 to DB-9 Console Cable
