Do not use this product near water, for example, in a wet basement or near a
swimming pool.
Avoid using this product during an electrical storm. There may be a remote risk of
electric shock from lightning.
Do not point or stare directly into the beam or into the optical port of the
transceiver when it is operating, as this can injure your eyesight.
SAFETY NOTICES
This is a class A product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures.
CE Mark Warning
Cautions
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
FCC STATEMENT
©2016 TP-Link
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на
відповідність вимогам нормативних документів та вимогам, що передбачені
чинними законодавчими актами України.
FX
On:
Power on
Off:
Power off
PWR
LFP
On:
LFP function enabled
Off:
LFP function disabled
TP
LED Explanation
On:
Valid link
Flashing:
Transmitting or receiving data
Off:
Invalid link
Link/Act
On:
Valid link
Flashing:
Transmitting or receiving data
Off:
Invalid link
Link/Act
On:
Operating in Half-Duplex mode
Off:
Operating in Full-Duplex mode
Flashing:
Data collision
FDX/Col
On:
Running at 100Mbps
Off:
Running at 10Mbps or no connection
SPD
IEEE 802.3, IEEE802.3u, IEEE802.3x
Standards
PWR, SPD, LFP, FDX, Link/Act
1 SC fiber optic; 1 RJ45 jack
External Power Adapter: 9V/0.6A
LED
Twisted-Pair
Connector
Operation Temperature
0
˚
C to 40
˚
C (32
˚
F to 104
˚
F)
Storage Temperature
-40˚C to 70˚C (-40˚F to 158˚F)
Storage Humidity
5% to 90% RH non-condensing
10BASE-T: 2-pair UTP/STP of Cat. 3 or above (≤100m)
100BASE-Tx: 2-pair UTP/STP of Cat. 5 or above (≤100m)
9/125μm single-mode fiber (≤20km)
Operation Humidity
10% to 90% RH non-condensing
General Specifications
Environmental and Physical Specifications
Fiber
Power
For MC111CS: 1550nm TX, 1310nm RX
For MC112CS: 1310nm TX, 1550nm RX
Wave Length
Specifications
