3
Figure 2
Step 4: Remove the dust plug from the transceiver.
Note:
Always keep the protective dust plug on the SFP+ transceiver’s optical bores
until you are ready to make a connection.
Step 5: Plug fiber into the transceiver and the SFP+ transceiver
can now begin operation automatically.
2.2 Removing the SFP+ Transceiver
Step 1: Wear an ESD-preventive wrist strap, and make sure the
wrist strap has good skin contact and is well grounded.
Step 2: Disconnect the network’s fiber-optic cable from the
transceiver.
Step 3: Release the transceiver latch by pulling down the handle
bar across the transceiver, then pull the transceiver out of the
SFP+ slot, as shown in Figure 3. Then immediately reinstall the
dust plug in the transceiver’s optical bores.
SFP+
