AP Management
You can change the IP address, mask, default gateway, web service port and web
session timeout of the CAP and enable the manage VLAN.
Figure 6-2 AP Management Page
IP Address:
Set the IP address through which the hosts in the LAN can visit the
CAP. The default setting is 192.168.0.254. You can change the IP
according to the network need.
Mask:
Set the mask of CAP. The default setting is 255.255.255.0. You can
change it according to the network need.
Default Gateway:
Set the default gateway of CAP. The default setting is 255.255.255.0.
You can change it according to the network need.
Manage VLAN:
Check the box to enable the manage VLAN. Specify the Manage
VLAN ID. The valid values are from 1 to 4094.
Manage VLAN provides a safer way for you to manage the CAPs.
With it enabled, only the hosts in the manage VLAN can log in to the
CAP’s webpage. Since most hosts cannot process VLAN TAGs, you
should connect the management host to the network via a switch.
Configure VLAN settings for the switches on the network to ensure
the communication between the host and the CAP in the manage
VLAN.
WEB Service
Port:
Set the Web service port for the CAP.
22
