5
Reset Button
3. Prior to use
Step 1: Open the Valve(s)
Open the valve(s) of the external fuel tank.
Step 2: Start the Fuel flow
If using heater for the first
time, or after heater has
been out of fuel, press the
red reset button once for a
period of one second in
order to send fuel to the fuel
sump.
Note: Make sure there is no fuel leakage from the
fuel line or joints.
Also make sure fuel tank is not too high. See
installation instructions.
Step 3: Set the top guard
The top guard is in the
carton box. Please take it
out from the box, and set it
on the top plate of the heater
before using it to prevent a
fire.
Step 4: Plug in the heater
Insert the plug into the wall-socket (220 Volts –
AC/50Hz).
Step 5: Setting the clock
Important: The clock on the heater must always be
set to the correct time.
It is only possible to set the correct time, when the heater
is connected to the mains and not burning.
Use the adjustment buttons to set the time.
First press either of the two buttons to switch on the
function "empty full"(the CLOCK light and the information
display will start blinking). Next, set the hours using the
button on the left (-HOUR) and the minutes using the
button on the right (+MIN.). Press once to increase the
value by one step. When you hold down the button, the
value will continue going up, until you release the button
again. After approximately 10 seconds the blinking will
stop and the setting will be locked. After switching off the
heater, the clock time will be displayed.
Fig. D-1 Operation panel
1. ON/OFF button:
The main switch to turn the heater on and off. Switch
it “ON” to activate the heater. Combustion will start
after a 2-6 minutes pre-heating period. The heater has
4 settings “HIGH”, “MEDIUM”, “LOW” and “OFF”.
2. Adjustment buttons:
Temperature selection switches offer the user the option
to select the desired temperature during operation.
3. Information display:
Displays the clock, set temperature, room temperature
and error codes.
4. Heat adjusting slide knob
・
Manual operation …
Slide the heat adjusting slide knob to right-side to
select your desired heat yield from “LOW” to “HIGH”.
・
Automatic operation …
Set the heat adjusting slide knob to left-side “Auto”
position to set the Automatic operation. The heater
will operate automatically in accordance with the set
and room temperature.
2. Operating elements and lights
5. SAVE button:
Allows you to limit the temperature. When this function
is activated, the heater will automatically switch off
and on again.
6. TIMER button:
Allows you to switch on the heater automatically at a
preset time.
7. CHILDPROOF LOCK button:
Can be used to prevent children accidentally changing
the heater settings.
8. Filter button:
This button is for releasing the filter lamp.
・
To release the filter lamp
When the filter lamp is on, please clean the fan filter
(See pages 10). After cleaning, please keep pressing
the filter button for more than 3 seconds. Then the
filter lamp will be off.
1. ON/OFF button
2. Adjustment buttons
4. Information display
3. Heat adjusting slide knob
5. Save button
8. Filter button
7. Childproof button
6. Timer button
