TROUBLESHOOTING
INFORMATION
Complaint: No Tail Light Or Marker Light Operation
Common causes for this complaint:
Mis-spliced Tail Light wire, connectors not plugged in securely, blown fuse.
RS3200PLUS SECURITY SYSTEM
What to Ask and Verify
What to Check
Do the vehicle’s tail
lights work?
Yes
Check and correct the tail light wire’s splice location (applies to most
vehicles).
Verify the splice connector was applied properly.
Verify the RS3200PLUS harness’ tail light circuit connectors are plugged
in securely.
Check for continuity between the RS3200PLUS ECU connector and the
tail light circuit connection.
No
Confirm that the vehicle’s connector for the tail light circuit is plugged
in securely.
Disconnect the RS3200PLUS harness’ tail light circuit connectors and
reconnect the vehicle’s connectors, then check the tail light function
again. If they work, check the RS3200PLUS harness. If not, the problem
is vehicle-related. (applies to some vehicles)
Complaint: LED Inoperative (No blinking, No turning on)
Common causes for this complaint:
Mis-spliced LED wire, mis-spliced door courtesy wire, connectors not plugged in securely.
RS3200PLUS SECURITY SYSTEM
What to Ask and Verify
What to Check
Does the LED blink dur-
ing arming?
Yes
No problem.
No
Check trunk key switch was installed properly.
If not correct, LED may not turn on.
Verify the splice connector was applied properly.
Is there continuity
on pin 10 of the
RS3200PLUS harness’
ECU connector?
Yes
Activate the panic mode and check pin 10 for pulsed continuity to
ground. If there is continuity, check the RS3200PLUS ECU for signs of
liquid damage; it may be necessary to open the ECU case. LIQUID
DAMAGE ITEMS ARE NOT COVERED UNDER WARRANTY.
No
Check and fix the RS3200PLUS harness.
