Page 8
TOYOTA
RS3200 REMOTE KEYLESS Security system
TOYOTA
RS3200 remote keyless Security system
Page 13
OPERATION
PASSIVE (AUTOMATIC) ARMING & DISARMING
When the RS3200 is programmed to P
ASSIVELY
A
RM
, the system will A
RM
after the ignition key is
removed and all doors and the trunk or hatch are closed; you do not need to lock the doors. When
you come back to your vehicle and open a door, you must insert the key into the ignition switch
and turn it to “ON” during the E
NTRY
D
ELAY
(0, 15 or 30 seconds), or an A
LARM
will be T
RIGGERED
. If
you lock the doors, regular A
RMING
will override P
ASSIVE
A
RMING
; there will be no E
NTRY
D
ELAY
. See
the PROGRAMMING section on page 15 to activate the P
ASSIVE
A
RMING
mode, as well as select the
E
NTRY
D
ELAY
time.
To P
ASSIVELY
A
RM
the system:
Remove the key from the ignition switch.
Exit the vehicle, and close all the doors. (
The system will not A
RM
while any of the doors are open.)
Close the trunk or hatch, if necessary. (
The system will not A
RM
while
the trunk or hatch is open.)
After the last door, trunk or hatch is closed:
The S
TATUS
M
ONITOR
’
S
LED turns on for 30 seconds, then
starts flashing.
�
The system is now A
RMED
.
To D
ISARM
the P
ASSIVELY
A
RMED
system:
Enter the vehicle through a front door.
The E
NTRY
D
ELAY
begins:
The S
TATUS
M
ONITOR
’
S
LED turns on (no flashing.)
�
Insert the key into the ignition switch and turn it to “ON” before the
E
NTRY
D
ELAY
ends.*
The LED turns off. The system is now D
ISARMED
.
You may also D
ISARM
the system following any of the methods
described on page 7.
NOTE: If your vehicle’s tail and marker lights turn on and the buzzer sounds for 2 seconds
when the system is D
ISARMED
, the T
RIGGER
M
EMORY
was activated; an A
LARM
was
T
RIGGERED
while you were away from the vehicle.
* If the E
NTRY
D
ELAY
time elapses before the ignition switch is turned to “ON”, an A
LARM
will be
T
RIGGERED
. To D
ISARM
the system during an A
LARM
, insert the ignition key and turn it to “ON”, or
press and release the remote control’s UNLOCK button.
THE SYSTEM ARMS
30
SECONDS
AFTER THE LAST ENTRY POINT
(
DOOR
,
TRUNK OR HATCH
)
IS CLOSED
THE SYSTEM DISARMS WHEN
YOU INSERT THE KEY AND TURN IT
TO
“
ON
”
LIGHTS FOR
30
SECONDS
(
PRE
-
ARMING
)
THEN STARTS
FLASHING
(
SYSTEM IS
ARMED
)
�
TURNS ON
(
NO
FLASHING
)
DURING THE
ENTRY DELAY
�
ALARM INFORMATION
ALARM DESCRIPTIONS
Regular A
LARM
�
When an A
LARM
is triggered in any way other than initial detection by the G
LASS
B
REAKAGE
S
ENSOR
,
the following occur:
The horn sounds repeatedly for 60 seconds.
The headlights flash repeatedly for 60 seconds.
The tail and marker lights flash repeatedly for 60 seconds.
The interior lights turn on for 60 seconds.
The starter is disabled (no engine start) until the system is D
ISARMED
.
The door lock will be relocked if someone reaches in and unlocks the inside lock button.
After 60 seconds of A
LARM
, the system will R
EARM
and continue to protect the vehicle.
W
ARN
-A
WAY
A
LARM
�
Upon initial detection of noise from tapping on, or breaking glass, the G
LASS
B
REAKAGE
S
ENSOR
T
RIGGERS
a W
ARN
A
WAY
A
LARM
:
The horn sounds repeatedly for 20 seconds.
The headlights flash repeatedly for 20 seconds.
The tail and marker lights flash repeatedly for 20 seconds.
The interior lights turn on for 20 seconds.
If the G
LASS
B
REAKAGE
S
ENSOR
detects noise again, or if a door or trunk or hatch is opened while the
system is still A
RMED
, the regular A
LARM
(described above) is activated.
STOPPING AN ALARM
Simply D
ISARM
the system using the remote control or key as described on page 7.
THE HORN SOUNDS
FOR
20
SECONDS
�
HEADLIGHTS FLASH
FOR
20
SECONDS
MARKER LIGHTS
FLASH
FOR
20
SECONDS
TAIL LIGHTS FLASH
FOR
20
SECONDS
THE HORN SOUNDS
FOR
60
SECONDS
HEADLIGHTS FLASH
FOR
60
SECONDS
THE STARTER IS DISABLED UNTIL
THE SYSTEM IS DISARMED
MARKER LIGHTS
FLASH
FOR
60
SECONDS
TAIL LIGHTS FLASH
FOR
60
SECONDS
INTERIOR LIGHTS TURN ON FOR
60
SECONDS
INTERIOR LIGHTS TURN ON FOR
20
SECONDS
�
