1. Raise and support front of vehicle. Remove clip, and disconnect fluid return hose. Use drain pan to catch
power steering fluid when connections are released. Remove clamps and holders from pressure feed pipe.
Remove pressure feed pipe from power steering gear.
2. Loosen top and bottom pump bolts, and remove drive belt. Disconnect oil pressure switch connector.
Loosen bolt hidden behind power steering pump drive pulley until power steering pump can be removed
(bolt cannot be fully removed). See
Fig. 2
.
3. Remove oil pressure switch from union bolt. Remove union bolt and gasket. Remove pressure feed line.
Fig. 2: Locating & Loosening Hidden Bolt Located Behind Power Steering Pump Drive Pulley (Sienna)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Removal (Tacoma & 4Runner 4-Cylinder)
1. Loosen power steering idle pulley bolt, then loosen belt adjusting bolt. Remove drive belt. Use 24-mm
spanner to hold pressure port union. Remove union bolt and gaskets. Remove pressure feed line from
pump.
2. Disconnect and plug return hose. Use drain pan to catch power steering fluid when connections are
released.
3. Remove pump bolts. Remove power steering pump.
Removal (Tacoma & 4Runner V6)
1999 Toyota RAV4
1999-2000 STEERING Power Rack & Pinion - Trucks
Microsoft
Sunday, November 22, 2009 10:35:46 AM
Page 5
© 2005 Mitchell Repair Information Company, LLC.
