Corolla
TNS600
Corolla (RHD) -
17
01-07
Fig. 23
MAP
DISC
CAUTION
NOTICE
CLOSE
Be careful not to injure
your fingers when opening
Do not place any objects on the panel
Do not leave the panel open when it is
DVD-ROM INSERTION INTO
THE NAVIGATION ECU
INSTALLATION
1. Connect the battery and turn the igni-
tion switch to the ACC position.
2. Press
open.
3. With the label side of the disc facing up,
insert the Navigation Disc into the disc
insertion slot.
* The disc will be pulled into the
computer automatically.
4. Press
close.
INSTALLATION OF NAVIGATION DISC
INSTALLATION OF NAVIGATION DISC
Installation Check
1. Inspect the wiring and installation for abnormalities.
2. Check particularly closely for any locations where the vehicle harness, wire harness or divergency harness is being pushed,
pulled or pinched with excessive force. Also check again that clamps and bands have not shifted out of position and that all parts
have been tightened.
Operation Check
1. Attach the (-) terminal of the battery and turn the key to the ACC or ON position or start the engine.
2. Press the NAVI switch and confirm that the navigation screen is displayed.
3. Adjust the volume by following the section on “Adjusting the Volume of the Guide Voice” in the TNS Owner’s Manual, and con-
firm that the sound from the speakers changes.
4. Perform the “auto-compensation” procedure by following the section on “When Tires are Replaced” in the TNS Owner’s Manual.
When an abnormality is suspected, perform troubleshooting based on the “Toyota Genuine Navigation System Service Manual”.
ENSURE THAT ALL REMOVED CONNECTORS ARE PUT BACK CORRECTLY.
REFIT THE TRIM AND REMOVED PARTS.
Return all vehicle parts that have been removed to their original locations. Especially make sure to attach trim and other inte-
rior materials properly so that they do not have a detrimental effect on the function of the vehicle. During restoration, make
sure that wires are not pinched and all bolts and screws are tightened.
REASSEMBLING