Toyota Celica 2002, Operating Manual

Page: 208 / 231

’02MY CELICA U (L/O 0108)
208
2002 MY CELICA_U (OM20792U)
NOTICE
Do not use engine antifreeze or any
other substitute because it may dam-
age your vehicle’s paint.
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent yourself from burning,
do not replace the light bulbs while
they are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.
NOTICE
Only use a bulb of the listed type.
Light bulbs
Bulb
No.
W Type
Headlights
(low beam)
—
55 A
Headlights
(high beam)
9005 65 B
Front fog light
—
55 C
Parking lights
—
5 D
Front turn signal
lights
—
21 E
Front side marker
lights
—
5 D
Rear turn signal
lights
—
21 D
Stop/tail lights
—
21/5 D
Back–up lights
—
18 D
License plate lights
—
5 D
Interior light
(with moon roof)
—
10 E
Interior light
(without moon roof)
—
8 F
Replacing light bulbs—