Toyota 2006 Land Cruiser, Owner'S Manual

Page: 166 / 364

152
$
Reorient or relocate the receiving an-
tenna.
$
Increase the separation between the
equipment and receiver.
$
Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
$
Consult the dealer or an experienced
radio / TV technician for help.
FCC WARNING:
Changes or modifications not ex-
pressly approved by the party respon-
sible for compliance could void the
user’s authority to operate the equip-
ment.
—Replacing tires and wheels
As you might have difficulty in locating
a flat or deflated tire, a tire pressure
warning system should be installed on
the tires of this vehicle.
When replacing the wheels, be sure to
install tire pressure sensors on the
wheels.
There are 3 ways to set up the tire pres-
sure sensors:
a. Remove the sensor from the old wheel
and install it to the new wheel.
b. Keep the same wheel with tire pres-
sure sensor and replace the tire alone.
c. Use a new wheel and sensor.
You have to register an ID code for a
new sensor. Up to 2 sets of codes
can be registered. As one ID for the
originally installed sensor is registered
at “MAIN” of the selector switch, use
the “2nd” position to register an ID for
the new sensor.
You do not need to re- register the ID
code for any other replacements. For
the use of the originally installed tires,
put the selector switch at “MAIN” and
for the use of tires set purchased later,
put the switch at “2nd”. For the sen-
sor selector switch, see page 154.
NOTICE
!
Have the tires, wheels or sensors
replaced and ID codes registered by
Toyota dealer. If you need sensors,
purchase from Toyota dealer.
!
The sensor nuts should always be
tightened to a torque of 4 N·m (0.4
kgf·m, 2.9 ft·lbf).
!
The use of non- genuine wheels will
cause the tire pressure sensors to
transmit the electronic code in dif-
ferent manner, resulting in the fail-
ure of the system.
!
Initialization should be performed
with the tires adjusted with the
tires adjusted at the specified set
tire inflation pressure. If they are
not adjusted properly, tire inflation
pressure to be warned will not be
appropriate. It takes about 20 min-
utes for initialization. Leave the
ignition on for about 20 minutes
after initialization.